This website uses cookies. By using this website you accept the use of them for our services.
Legal Notice / Aviso Legal

xDS Interface (Suzuki, Honda, Kawa)

200.00 €*
(Prices do not include VAT)

USB xDS Interface

This xDS Interface provides a quick way to record the motorcycle's engine RPM, and engine coolant temperature, this is specially useful with on-spark coils, in which the inductive clamp maybe too big to fit in, and difficult to access.

xDS interface + USB adapter

(SportDyno communicates directly with the xDS interface. This makes possible to use xDS link with SP1 or SP5)


  • USB Interface, 6 meter cable lenght (cable transmits serial data to reach higher noise immunity, USB adaption is provided only at the end of the cable)

  • This interface is managed directly by SportDyno (3.9+), it does not depend on the SP1/SP3/SP4/SP5 version

  • Supports the following brands:

    • SDS Suzuki
    • HDS Honda
    • KDS Kawasaki

    Check channels available per brand below:

    ChannelSDS SuzukiHDS HondaKDS Kawasaki
    Engine RPM
    Engine Coolant Temp
    Throttle Position
    IAP1 Intake Air Pressure 1
    IAT Air Intake Temp
    Battery Voltage
    Vehicle Speed
    STP Secondary Throttle
    Cilynder 1 Advance
    Cilynder 2 Advance
    Cilynder 3 Advance
    Cilynder 4 Advance
    Driving Selection Mode 1&2
    Exhaust Control Valve
    IAP2 Intake Air Pressure 2
    Idle Target RPM
    ISC Valve Position
    Cilynder 1 Injection Time
    Cilynder 2 Injection Time
    Cilynder 3 Injection Time
    Cilynder 4 Injection Time
    Starter Signal
    Tip Over Sensor
    Ignition Key
    O2 Select Control Terminal
    Exhaust Valve Ctrl Terminal
    Neutral Switch
    Cootdng Fan status
    Pair Solenoid status

xDS Window

The Following Screenshots have been taken from SportDyno Version 4.0

In this window the computer shows the available channels, and the user can select those channels that want to acquire. Suzuki and Honda motorcyles send all channels every time, but with Kawasaki motorcycles each new channel has to be requested and make the communictions slower. In the example only Engine RPM and speed are selected

After selecting which channels are going to be used in the system, these channels can be used either on the Ratio Window or during the recording of the test

Ratio Window

Channel Selector

(Gauges Window)

List of XDS channels is added to the main Channel List of the program, so they can be displayed in the Gauges Window